Galcon Bakarim Agricultural Cooperative Society Ltd G2W3GA Manual De Usuario
A Safety Instructions for Installing Antennas
Do not climb on the antenna pole. In order to lower/raise the antenna for maintenance operations,
remove one of the anchoring screws and lower the antenna and axis to the floor.
remove one of the anchoring screws and lower the antenna and axis to the floor.
Do not set up antennas near high voltage lines.
Make sure that the base of each antenna is properly positioned and affixed to the concrete floor.
Make sure that the antenna pole is properly connected and secured to the base.
When the antenna pole is higher than 6 meters, the antenna pole must be secured by 3 additional
metal cables from the top of the pole to the ground. Mark the cables according to the applicable
safety regulations.
metal cables from the top of the pole to the ground. Mark the cables according to the applicable
safety regulations.
Warning! Only personnel with the necessary official qualifications, including passing the
official Ministry of Labor climbing course, may climb antenna poles. While doing so, all such
personnel must follow all of the applicable safety regulations.
official Ministry of Labor climbing course, may climb antenna poles. While doing so, all such
personnel must follow all of the applicable safety regulations.
The antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 1 m from all persons
of at least 1 m from all persons
FCC Compliance Statement
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential
installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio and television reception.
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause
such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the
interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one that supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential
installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio and television reception.
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause
such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the
interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one that supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
could void the user’s authority to operate the equipment.