Precor PRCR0111 Manual De Usuario
34
Assembling the Atlas Treadmill
Connecting Cables (AT-75 Display)
After the display has been seated, separate the individual
cables out of the end of the cable assembly and attach
them to the appropriate circuit connectors inside the
display. Refer to the following diagram and table to
identify the cables and connectors.
cables out of the end of the cable assembly and attach
them to the appropriate circuit connectors inside the
display. Refer to the following diagram and table to
identify the cables and connectors.
Caution: Many of the connectors are keyed or polarized and
will fit together in only one way. However, because some of
the strip connectors are not keyed or polarized, they can be
connected in inappropriate ways.
will fit together in only one way. However, because some of
the strip connectors are not keyed or polarized, they can be
connected in inappropriate ways.
When attaching unkeyed, unpolarized strip connectors,
identify the shaded or striped lead on the connector and make
sure to attach it to the pin labeled as pin 1 on the circuit board.
Attaching unkeyed connectors the wrong way can cause damage
to the display, the circuitry in the base unit, or both.
identify the shaded or striped lead on the connector and make
sure to attach it to the pin labeled as pin 1 on the circuit board.
Attaching unkeyed connectors the wrong way can cause damage
to the display, the circuitry in the base unit, or both.
Figure 16: Cable connections, AT-75 display