YEALINK NETWORK TECHNOLOGY CO. LTD. T40G Manual De Usuario

3

Configuring via web user interface
Accessing the web user interface:
1. Press the 

OK key when the phone is idle to obtain the IP address of the phone. 

2. Open the web browser of your computer, enter the IP address into the address bar (e.g.,  
    "http://192.168.0.10" or "192.168.0.10"), and then press the

 Enter.

3. Enter the user name (default: admin) and password (default: admin) in the login page and click 

Confirm.

Note: 

Check with your system administrator if any error appears during the registration process or if a specific 

         configuration is required for your registration.

Note: 

The IP phone also supports IPv6, but IPv6 is disabled by default.

          The wrong network settings may result in inaccessibility of your phone and may have an impact on the 

          network performance. Contact your system administrator for more information.

Account Settings: Click on Account->Register->Account X (X=1,2,3)
Parameters of the account:             
Register Status:                            
Line Active:                            
Label:                                         
Display Name:                            
Register Name:                            
User Name:                                
Password:                                    
Server Host:                                

It is provided by ITSP for registration (required).

It is provided by ITSP for registration (required).

It is authenticated ID for authentication provided by ITSP (required).

 It is shown as Caller ID when placing a call.

It is shown on the LCD screen to identify the account. 

You can select Enabled/Disabled to enable/disable the account. 

It shows the register status of the current account.

Note: 

For more information on account parameters, refer to 

Configuring via web user interface above.

Network Settings: Click on Network->Basic->IPv4 Config
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid network     
            settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address: If your phone cannot contact a DHCP server for any reason, you need to configure the IP   
                              address, subnet mask, gateway address, primary DNS address and secondary DNS address  
                              for the phone manually.

It is provided by ITSP for registration (required).

Configuring via phone user interface
Network Settings:
Press the 

Menu soft key when the phone is idle, select Settings->Advanced Settings (default password: 

admin)->

Network->WAN Port/VLAN/Web Server/802.1x/VPN/LLDP/CDP/NAT to configure the network.

Account Settings:
Press the 

Menu soft key when the phone is idle, select Settings->Advanced Settings (default password: 

admin)->

Accounts to configure the account.

Registered

Register Failed

Registering