ey Security Solutions Inc. SDC2K Manual De Usuario
Installation Instructions for Stanley Omnilock 45HOM Mortise Locks
Stanley Omnilock
a Product Group of Stanley Security Solutions, Inc.
12
Finishing the installation
20
Troubleshooting
If the mechanism doesn’t unlock, remove the battery
cover and check for proper orientation and seating of
the batteries and motor connector. Ensure that wires
are not pinched. Reset the electronics by pressing
and holding the reset button on the circuit board
until the light flashes green (approximately three
seconds), then releasing the botton. See Figure 21.
Note: The system will go through a self-test and the
green light will flash five times. You will hear the
lock unlock, then relock three times. A red flash
indicates a PC board or drive system problem. If a
red flash or no flash is observed, check for proper
orientation and seating of the batteries and motor
connector, ensure that wires are not pinched, then
repeat the reset process.
Check operation
1 Press
1234 for the 2000 series, or 5011234
for the 500 series.
During the unlock time, the green light flashes; then
the red light flashes and the latch relocks.
2 Turn the lever and open the door.
3 If your system has a magnetic card reader, verify
3 If your system has a magnetic card reader, verify
proper operation of the system using the
magnetic card reader; otherwise, see “Test lock”
on page 11.
A label on the housing assembly battery cover indi-
cates the magnetic card track (track 2 or track 3) that
the system is set to read. See Figure 11.
Figure 21 Using the reset button
Reset button
Motor connector
Red wire
Black wire
Motor connector
Red wire
Black wire
Terminal block