ads-tec GmbH RAX1X2X Manual De Usuario
User Manual
User Manual
User Manual
User Manual Access Point /Client V 3.0.3
Access Point /Client V 3.0.3
Access Point /Client V 3.0.3
Access Point /Client V 3.0.3
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
97
97
97
97
8.2.3
8.2.3
8.2.3
8.2.3
Adv.
Adv.
Adv.
Adv. WLAN
WLAN
WLAN
WLAN
IAPP
The IAPP is employed to exchange control and additional information between Access
Points. For instance, an AP sends an IAPP notification to all other APs in the same network
whenever a new client logs into the network. All other APs may then remove that client from
their table of logged-in clients. Regardless of this setting, an LLC Xid packet, originally also
defined as part of the IAPP, will be transmitted in any case whenever a client logs into the
network.
Points. For instance, an AP sends an IAPP notification to all other APs in the same network
whenever a new client logs into the network. All other APs may then remove that client from
their table of logged-in clients. Regardless of this setting, an LLC Xid packet, originally also
defined as part of the IAPP, will be transmitted in any case whenever a client logs into the
network.
Activate IAPP
This option enables IAPP broadcasts and reception of IAPP messages on Access Points.
Activate IAPP Client Update
This option enables a special ads-tec extension of the IAP protocol. This extension will, at a
1 second interval, send the 802.11 beacon information via the Ethernet as an IAPP
broadcast. ads-tec clients are able to receive these messages and can thus obtain
information about all APs in the network, independent of whether these APs are already
visible to the client through a wireless connection. This information is particularly useful for
automatic channel resolution in the 5 GHz band when using fast roaming.
1 second interval, send the 802.11 beacon information via the Ethernet as an IAPP
broadcast. ads-tec clients are able to receive these messages and can thus obtain
information about all APs in the network, independent of whether these APs are already
visible to the client through a wireless connection. This information is particularly useful for
automatic channel resolution in the 5 GHz band when using fast roaming.
Hence, this option is only useful when fast roaming is employed.
Note:
The IAPP (Inter-Access Point Protocol) was defined in the IEEE 802.11f recommendation.
It was only defined as a trial use recommendation and withdrawn in 2006. Consequently,
IAPP is not a standardised protocol.
It was only defined as a trial use recommendation and withdrawn in 2006. Consequently,
IAPP is not a standardised protocol.