TP-Link Technologies Co. Ltd. C5400 Manual De Usuario

80

Chapter 12

Customize Your Network Settings

1.  Change the router’s LAN IP addresses to two different IP 

addresses on the same subnet. Disable Router 2’s DHCP 
function.

2.  Visit 

, and log in with the username and 

password you‘ve set for the router. 

3.  Go to

 Network 

> 

Advanced Routing

. 

4.  Click 

Add

 and finish the settings according to the following 

explanations:

Network Destination: 

The destination IP address that you want 

to assign to a static route. This IP address cannot be on the same 
subnet with the WAN IP or LAN IP of the router. In the example, 
the IP address of the company network is the destination IP 
address, so here enters 172.30.30.1. 

Subnet Mask:

 Determines the destination network with the 

destination IP address. If the destination is a single IP address, 
enter 255.255.255.255; otherwise, enter the subnet mask of 
the corresponding network IP. In the example, the destination 
network is a single IP, so here enters 255.255.255.255.

Default Gateway:

 The IP address of the gateway device to which 

the data packets will be sent. This IP address must be on the 
same subnet with the router’s IP which sends out the data. In 
the example, the data packets will be sent to the LAN port of 
Router 2 and then to the Server, so the default gateway should 
be 192.168.0.2.