Outsite Networks Inc. APX-2012 Manual De Usuario
AllPoints Keypad Installation Manual
Page 13
When an AP Keypad unit is configured for Unit Mode “1”, the Use DHCP configuration
item will automatically be set to “1” which means it will use DHCP. It will by default be
ready to connect to the Internet using DHCP. If DHCP is appropriate for the Internet
service at the site no further Internet options need to be configured.
item will automatically be set to “1” which means it will use DHCP. It will by default be
ready to connect to the Internet using DHCP. If DHCP is appropriate for the Internet
service at the site no further Internet options need to be configured.
The Use DHCP values are:
Do not use DHCP
Do not use DHCP
= “0”
Use DHCP
= “1”
To set the Use DHCP item value to “0” meaning do not use DHCP”, press 3/2C or the
“3” key followed by the “2” key and then follow the printed directions.
11.2.8.
Configure Static IP settings
If the Internet service at the site requires a static IP address and the Use DHCP item has
been configured to “0”. Then it will be necessary to set the IP address, Subnet Mask,
Gateway and DNS values per the Internet Service provider’s requirements.
Press the appropriate Menu keys (#/#) to select the item and then follow the printed
instructions. (Use the table, on the next page, as a place to write the required
configuration information)
Configuration
Menu Keys
Internet Address
Menu Item
Part 1 Part 2 Part 3 Part 4
# # #
# # #
# # #
# # #
3/3
IP Address 1
______
______
______
______
3/4
Subnet Mask
______
______
______
______
4/2
Default Gateway
Index
Index
4/3
Default Gateway 1
______
______
______
______
4/4
Default Gateway 2
______
______
______
______
4/5
Default Gateway 3
______
______
______
______
5/2
DNS Server Index
5/3
DNS Server 1
______
______
______
______
5/4
DNS Server 2
______
______
______
______
5/5
DNS Server 3
______
______
______
______