Newer Technology Inc. MXP802NPCM Manual De Usuario

 

5

1. Peer-to-Peer: Connects with other wireless client(s). This does not require Access Point. Please 

make sure the “Network Name” (SSID or ESSID) and “Peer-to-Peer” channel are the same for 

all clients in the same wireless network. Double click on the Configuration Utility icon to open the 

utility.  

- Click on “Profile Setting” tab and “Add” to create a new profile.   

- Enter a name that the profile correspond, click “Next”. 

- Select the “Network Type”, click on the drop-down arrow and select “Peer-to-Peer”, and then at 

“Peer-to-Peer Channel”, use the up/down arrows to select the channel number, and then click 

“Next”. 

- Select the Authentication Mode to enable the “Encryption” if you have any security concern. 

Once you enable the encryption function, then you should input the corresponding key. Click 

“Next”. 

-  On IP Setting select “Enable” or “Disable” to make used of it. Click       

“Complete” to finish the configuration. 

 

 

2. Access Point: Connects to network via Access Point.   

- Click “AP List” tab. 

- Select the listed Wireless Network to Join.   

- Click “Connect” to join the network. 

 

* Note: You might need to configure a Profile before if the destination network had a “WEP KEY” 

protected. 

 

The equipment has been tested and found to comply with FCC and CE Rules.Operation is subject to the following 

two conditions: 

 

(1)      This device may not cause harmful interference. 

(2)      This device must accept any interference received including interference that may cause undesired operation.