Lytx Inc. QCA6134 Manual De Usuario
ER-SF1 Event Recorder with J1939 Network Instructions for Self Installation
© 2017 Lytx, Inc. – Confidential & Proprietary – For Velociti’s Use Only Re Beta ER-SF1 Installations. Page 3 of 26
SAFETY INSTRUCTIONS
Installation Safety Warnings
Read and follow the instructions and precautions in this guide and all documents
referenced in this guide when installing this device. Always refer to the vehicle manufacturer’s
service manual for proper installation and wiring of any aftermarket devices, including the ER-SF1.
Failure to do so may result in property damage and/or personal injury.
referenced in this guide when installing this device. Always refer to the vehicle manufacturer’s
service manual for proper installation and wiring of any aftermarket devices, including the ER-SF1.
Failure to do so may result in property damage and/or personal injury.
WARNING:
Park the vehicle on a level surface before beginning any maintenance or
installation. Block the wheels to prevent the vehicle from moving. Never work under a vehicle
supported only by jacks as jacks can slip and fall over.
supported only by jacks as jacks can slip and fall over.
WARNING:
All wires that carry electrical current must be fused. Failure to do so can lead
to serious personal injury and/or property damage. If any wires or cables containing fuses/fuse
boxes need to be cut or otherwise shortened, always be certain to replace such fuses/fuse boxes
or install new ones.
boxes need to be cut or otherwise shortened, always be certain to replace such fuses/fuse boxes
or install new ones.
WARNING:
Wire Protection: Take all necessary measures to protect all wire runs through a
metal surface with a grommet or other device and all wire runs outside the vehicle cab with a
loom. Always protect against wire fatigue and harness abrasion by properly attaching wires at
closely spaced intervals, while avoiding contact with sharp edges or doing anything else that might
result in exposed wires. All wires should be secured with tie wraps at least every two feet or less.
Do not overtighten any tie wraps.
loom. Always protect against wire fatigue and harness abrasion by properly attaching wires at
closely spaced intervals, while avoiding contact with sharp edges or doing anything else that might
result in exposed wires. All wires should be secured with tie wraps at least every two feet or less.
Do not overtighten any tie wraps.
EXPLOSION HAZARD:
Do not disconnect equipment unless power has been removed or the area
is known to be non-hazardous.
WARNING:
Substituting or supplementing components may impair suitability and
performance. If you are missing any components contact Lytx U.S. Technical Support Center at
866.910.0403 or email
866.910.0403 or email
WARNING:
Wear safe eye protection to prevent serious eye injury when you perform
vehicle maintenance or service.
Driver Safety Warnings
WARNING:
Seat belt warning: To reduce the potential danger of injuries, the driver and front
passenger must always be correctly seated with seat belts correctly fastened when operating the
vehicle.
vehicle.