Guangzhou Chiyuan Electronic Co. Ltd. X-3S Manual De Usuario
R/C
Introduction Manual
24
3.3 Connection between Receiver and Servos(2.4G)
R/C
Introduction Manual
3.2 Handling Procedure For Batteries
23
!
!
!
!
Battery Replacement
1.Remove the battery cover from the transmitter by sliding it in the direction of the arrow .
2. Remove the used batteries.
3.Load the new AA size batteries. Pay very close attention to the polarity marking and
reinsert accordingly.
4 .Slide the battery cover back onto the case.
2. Remove the used batteries.
3.Load the new AA size batteries. Pay very close attention to the polarity marking and
reinsert accordingly.
4 .Slide the battery cover back onto the case.
Caution
Always be sure your reinsert the batteries in the correct polarity order. If the batteries are
loaded incorrectly, the transmitter may be damaged.
When the transmitter is not used , always remember to remove the batteries. If the batteries
do happen to leak, clean the batteries case and contacts thoroughly. Make sure the contacts
are free of corrosion.
loaded incorrectly, the transmitter may be damaged.
When the transmitter is not used , always remember to remove the batteries. If the batteries
do happen to leak, clean the batteries case and contacts thoroughly. Make sure the contacts
are free of corrosion.
Battery Disposal
Some countries require special handling of used of batteries ,please contact the agencies
responsible for recycling hazardous wastes in your local area.
responsible for recycling hazardous wastes in your local area.
Battery low voltage alarm indicator.
Technology Data
TRANSMITTER
Channels: 3
Frequency: 2.4G
DC: 6.0V,≤150mA
Net weight: 342g
Spread spectrum mode:FHSS
RECEIVER
Channels: 3
Frequency: 2.4G
DC: 4.5~5.5v,≤30mA
Net weight: 5.0g
Spread spectrum mode:FHSS
ESC
SERVO3(CH3)
SERVO1(ST.)
SERVO2(TH.)
BATT.( 4.8V)
XY3000 XY3100 XY300P XY4000 8183
/
/
/
/
+ -
MINI
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be collocated or operating in conjunction with
any other antenna or transmitter.