Accton Wireless Broadband Corp. FIU176205000W Manual De Usuario
System Configuration
5-12
5
- Manually: If the 3G start mode is set to “Manually”, then you can only connect to
the 3G Internet service by pressing the 3G button on the wireless AP/Router or
by using the web interface.
by using the web interface.
Figure 5-9 Manually Start 3G
• Pin Code Protect: Enables the use of a PIN code (personal identification number)
to encrypt access to the wireless 3G connection. Some service providers do not
require PIN code authentication. If a PIN code is not required for your 3G/3.5G
modem, disable this function. (Default: Enabled) Specifies a PIN code number that
corresponds with that set on your 3G/3.5G USB modem and displays the status of
the 3G connection.
- Not dialed yet: Indicates that the 3G is not dialed and PIN is not authenticated
require PIN code authentication. If a PIN code is not required for your 3G/3.5G
modem, disable this function. (Default: Enabled) Specifies a PIN code number that
corresponds with that set on your 3G/3.5G USB modem and displays the status of
the 3G connection.
- Not dialed yet: Indicates that the 3G is not dialed and PIN is not authenticated
yet.
- Authenticated successfully: Indicates that the 3G connection has
authenticated successfully.
• Dial Code: A dialled access code that connects the USB device to the service
provider.
• APN Service: The name that uniquely identifies the cellular operator, access point
name (APN).
• 3G Username: The username of the account registered with the service provider.
• 3G Password: The password of the account registered with the service provider.
• Connect Type: Selects the connection type as Keep Alive or Auto Connect.
• 3G Password: The password of the account registered with the service provider.
• Connect Type: Selects the connection type as Keep Alive or Auto Connect.
(Default: Keep Alive)
• 3G Max Idle Time: The maximum length of inactive time the unit will stay
connected to the DSL service provider before disconnecting. This feature only
works when Connect Type is set to "Auto-Connect." (Default: 300 seconds)
works when Connect Type is set to "Auto-Connect." (Default: 300 seconds)