Applied Wireless Identifications Group Inc. R27CA012 Manual De Usuario
MPR-2010BR
Page 9
Doc# 041318
3.6 GROUNDING
Grounding is critical for proper operation of MPR-2010BR. When installing the reader, it
is crucial to assure that the earth ground is the best ground available. If you elect to use
the 120 VAC power ground, conduct a test by measuring its resistance relative to a
known good ground, such as a cold water pipe or structural steel that is in direct contact
with the ground. The resistance should be less than 50 ohms.
is crucial to assure that the earth ground is the best ground available. If you elect to use
the 120 VAC power ground, conduct a test by measuring its resistance relative to a
known good ground, such as a cold water pipe or structural steel that is in direct contact
with the ground. The resistance should be less than 50 ohms.
4 INSTALLATION PROCEDURE
This section provides information on installation and operation of MPR-2010BR readers.
4.1 PARTS LIST
Verify that all items listed below are present before starting the installation.
a.
Sentinel-Sense
MPR-2010BR
Qty=1
b.
Documentation
and
Demo
Program
CD
Qty=1
c. Power supply PS9-2A-SW, 50-60 Hz and 110 to 220 VA
Qty=1
d. LRMB Reader mounting bracket (Optional)
4.2 PREPARATION FOR INSTALLATION
Familiarize yourself with the connectors and pin out assignment of each I/O connectors
as shown in section 2.2.1.
as shown in section 2.2.1.
4.2.1 Bench Top Verification
It is always a good idea to verify system operation before committing to a full-scale
installation. The following are the necessary steps to test the reader s operation in a
static environment.
installation. The following are the necessary steps to test the reader s operation in a
static environment.
q
Connect MPR-2010BR to the RS-232 port of a PC
q
Connect the power jack from the wall plug power supply to MPR-2010BR.
q
Power up PC
q
Install demo software on PC
q
Activate demo software and verify performance of the reader.
q
Select COM port 1 on top page then click Connect . Follow with some
commands.
commands.
q
Place the RFID tags at the exact same locations as the final configuration
q
Measure tag s read distance and confirm that read distance is correct.
4.2.2 Aiming of Antenna
Antenna Pattern for MPR-2010BR