Conexant Systems Inc. 37704C Manual De Usuario

Preliminary User manual 

FCC ID: OSZ37704C 

 

Page 8 of 10 

 

 

 
This product does not contain any user serviceable components and is to be used with approved 
antennas only. Any product changes or modifications will invalidate all applicable regulatory 
certifications and approvals 

 

 
This Indigo device complies with the standards as shown in table below: 
 
country Approval 

USA 

FCC part 15, sections 15.107, 15.109, 15.207, 
15.209, 15.407 

Tested at accredited laboratories 
and filed for FCC certification. 

European Union 

EN 301 893 V1.1.1 (2001-01) 
ETSI EN 301 489-1 V1.3.1 (2001-07) 
ETSI EN 301 489-17 V1.1.1 (2000-09) 
EN60950 incl A1, A2, A3, A4 

Tested at accredited laboratories 
and Notified according to article 6.4 
of the RTTE directive 

Japan 

ARIB STD T71 v.1.0, 14 december 2000 

Tested at TELEC laboratories and 
filed for MPT Japan certification. 

 

 

 

 
2.3 USA-FCC (Federal Communications Commission) statement 

 
This device complies with Part 15 of FCC Rules. 
Operation is subject to the following two conditions: 

1. 

This device may not cause interference, and 

2. 

this device must accept any interference, including interference that may cause undesired 
operation of this device. 

 

 

 

2.4 FCC Interference Statement 
 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. 
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance 
with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee 
that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the 
following measures: 

1. 

Reorient or relocate the receiving antenna. 

2. 

Increase the distance between the equipment and the receiver. 

3. 

Connect the equipment to an outlet on a circuit different from that to which the receiver is 

 connected. 

4. 

Consult the dealer or an experienced radio/TV technician for help.