Arescom Inc. AG2000S Manual De Usuario
Basic - SETUP
12
June, 2002
AG2000Series Software User’s Guide
4.2 Basic - SETUP
Figure 4.2
SETUP Page
Use the SETUP page to configure the AG2000’s WAN interface, ISP, and Cable modem settings.
4.2.1 ISP Settings
There are three options for you to setup the AG2000’s WAN interface:
If you select the option Obtain an IP Address automatically from your ISP, the AG2000’s DHCP cli-
ent will request a dynamic IP address, subnet mask, and Gateway IP address from your ISP’s DHCP
server. Unless your ISP provides you a static (permanent) IP address, you should select this mode for
the AG2000.
ent will request a dynamic IP address, subnet mask, and Gateway IP address from your ISP’s DHCP
server. Unless your ISP provides you a static (permanent) IP address, you should select this mode for
the AG2000.
If you select the option Obtain an IP Address automatically from PPPoE session, then you need to
manually enter the required values listed below:
manually enter the required values listed below:
Username:
The name of the Internet account provided by your ISP.
Password:
The password you use to access your ISP account.
If you select the option Use a static IP address provided by ISP, you need to manually enter the
required values listed below:
required values listed below:
IP Address:
Enter AG2000’s WAN IP address provided by your ISP.
Subnet Mask:
Enter AG2000’s WAN subnet mask provided by your ISP.
Gateway IP Address:
Enter AG2000’s Gateway IP Address provided by your ISP.
Primary DNS:
Allows you to assign the IP Address of the Primary DNS provided by your ISP.