Wistron Corporation TP00076BUC Manual De Usuario
If your computer tries to enter sleep mode but the request is rejected, the device attached to the USB
connector might have been disabled. If this occurs, do a hot-unplug-and-plug operation for the USB
device.
connector might have been disabled. If this occurs, do a hot-unplug-and-plug operation for the USB
device.
• Problem: The battery discharges slightly while the computer is in hibernation mode.
Solution: If the wakeup function is enabled, the computer consumes small amount of power. This is not a
defect. For more information, see “Power-saving modes” on page 39.
defect. For more information, see “Power-saving modes” on page 39.
A solid-state drive problem
Problem: When you compress files or folders by use of the data compression function in Windows, and
then decompress them, the process of writing to or reading from the files or folders is slow.
then decompress them, the process of writing to or reading from the files or folders is slow.
Solution: Apply the disk defragmentation tool in Windows for faster access to the data.
A software problem
Problem: An application does not run correctly.
Solution: Make sure that the problem is not being caused by the application.
Check that your computer has the minimum required memory to run the application. Refer to the manuals
supplied with the application.
supplied with the application.
Check the following:
• The application is designed to operate with your operating system.
• Other applications run correctly on your computer.
• The necessary device drivers are installed.
• The application works when it is run on some other computer.
• Other applications run correctly on your computer.
• The necessary device drivers are installed.
• The application works when it is run on some other computer.
If an error message is displayed while you are using the application program, refer to the manuals supplied
with the application.
with the application.
If the application still does not run correctly, contact your place of purchase or a service representative
for help.
for help.
Problems with ports and connectors
The following are the most common problems with ports and connectors.
A USB problem
Problem: A device connected to the USB connector does not work.
Solution: Open the Device Manager window. Make sure that the USB device setup is correct, and that the
assignment of computer resource and the installation of the device driver are correct. To open the Device
Manager window, go to Control Panel and click Hardware and Sound
assignment of computer resource and the installation of the device driver are correct. To open the Device
Manager window, go to Control Panel and click Hardware and Sound
➙ Device Manager. If you are
prompted for an administrator password or confirmation, type the password or provide confirmation.
Refer to “Diagnosing problems” on page 93 and run a diagnostic test of the USB connector.
A ThinkPad Pen Pro problem
Problem: The ThinkPad Pen Pro does not perform well.
107