Wistron Corporation TP00082A Manual De Usuario

Descargar
Página de 8
FCC RF exposure compliance
The radiated output power of your system is far below the FCC radio frequency exposure limits.
Nevertheless, it shall be used in such a manner that the potential for human contact during normal operation
is minimized as follows:
CAUTION:
The radiated energy from the antennas conforms to the FCC limit of the SAR (Specific Absorption
Rate) requirement regarding 47 CFR Part 2 Section 1093, when the tablet operates in the conventional
setting. The SAR is determined to measure at the highest power level in each frequency band.
However, the actual SAR level in the operation bands is well below the maximum value in some
measurement plots. Because the tablet adjusts the cellular transmission power automatically based
upon the proximity to the human body and orientation. Namely, the closer distance to you from the
tablet, the lower the cellular transmission power level. The tablet has been tested and found to
meet the FCC RF exposure guidelines.
The transmission antennas for the wireless LAN module are located in the LCD cover. See “Locating the
UltraConnect
wireless antennas” in User Guide.
Simultaneous use of RF transmitters
Your tablet is approved for simultaneous use of one of the approved wireless LAN modules, the approved
wireless WAN module, and the approved NFC module. For a list of those transmitters, refer to the following:
• “About this manual” on page
• ThinkPad Regulatory Notice
Make sure of the following conditions when you use any other external RF option device:
1. When you use any other RF option device, you are requested to confirm that the device conforms to
the RF Safety requirement and is approved to use for your tablet.
2. You must follow the RF Safety instructions of the RF option device that are included in the user manual
of the RF option device.
3. If the RF option device is prohibited to use in conjunction with another transmitters, you must turn off all
other wireless features in your tablet.
Radio Frequency interference requirements
Each device has been tested and found to comply with the limits for a Class B digital device pursuant to
FCC Part 15 Subpart B. Refer to “Electronic emission notices” on page 5.
When you use a wireless LAN module in the 802.11 a/n transmission mode, note that high power radars are
allocated as primary users of the 5250 to 5350 MHz and 5650 to 5850 MHz bands. These radar stations can
cause interference with and/or damage this device.
Canada — Industry Canada (IC)
IC certification number
This system contains the following wireless devices and the IC certification number is as below. The IC
certification number is indicated on the bottom cover of your system.
• IC: 4182A-TP00082A
– Wireless LAN module with Bluetooth function (model: 8260D2W)
• IC: 4182A-TP00082AUC
2