Wistron Corporation MS2146BG Manual De Usuario
4. Enter the network SSID, in the Network Name (SSID) field.
5. Click Infrastructure or Ad hoc for the operating mode.
6. Click Password protect this profile to set a password for the profile.
7. The Mandatory AP option is only used if Infrastructure mode is selected. Use this
5. Click Infrastructure or Ad hoc for the operating mode.
6. Click Password protect this profile to set a password for the profile.
7. The Mandatory AP option is only used if Infrastructure mode is selected. Use this
option to connect to a specific access point. Click the Mandatory AP button, enter
the Ethernet address for the access point. Click OK to save the setting and return
to the General Settings page.
the Ethernet address for the access point. Click OK to save the setting and return
to the General Settings page.
8. Click the Enable Cisco Client eXtentions option to enable CKIP data encryption.
9. Check Enable Auto-Import to allow this profile to be imported. Refer to
9. Check Enable Auto-Import to allow this profile to be imported. Refer to
10. Click Next.
Security Settings
11. Select Open or Shared in the Network Authentication options. Open, does not use
any authentication method. Shared uses the WEP key as the authentication
method.
method.
12. Select either None, WEP or CKIP (if Enable Cisco Client eXtentions is enabled
on the General Settings page) for the data encryption.
13. If WEP is selected, select either 64 or 128-bit for the Encryption Level.
14. Select the key index 1, 2, 3 or 4.
15. Enter the required pass phrase or hex key.
16. Click the 802.1x Enabled checkbox to enable the 802.1x security option.
17. Select MD5 as the 802.1x Authentication Type.
18. Click the Configure button to open the MD5 Setting dialog. Enter the user name
14. Select the key index 1, 2, 3 or 4.
15. Enter the required pass phrase or hex key.
16. Click the 802.1x Enabled checkbox to enable the 802.1x security option.
17. Select MD5 as the 802.1x Authentication Type.
18. Click the Configure button to open the MD5 Setting dialog. Enter the user name
and password of the user you have created on the authentication server. The user
name and password do not have to be the same as name and password of your
current Windows user login.
name and password do not have to be the same as name and password of your
current Windows user login.
19. Click Close to save the settings.
20. If the Password Protection checkbox was checked on the General settings page,
20. If the Password Protection checkbox was checked on the General settings page,
then
click Next to display the Password page.
click Next to display the Password page.
Password Protection Settings
21. Click the Password protect this profile checkbox.
22. Enter a password in the Password field.
23. Reenter the same password in the Confirm New Password field.
24. Click the Back button to change or verify the settings or click Finish when you
22. Enter a password in the Password field.
23. Reenter the same password in the Confirm New Password field.
24. Click the Back button to change or verify the settings or click Finish when you