RadioFrame Networks Inc DH2 Manual De Usuario
Method of Procedure
Installation
Installation
72
RFN_3.1 Beta
Figure 22
The URU dip switch is located on the bottom of the unit and is used to
configure the input and output power for the unit.
configure the input and output power for the unit.
4.4 RFU
This section describes the methods used to mount an RFU, including both wall
and ceiling mounts. The RFU is shipped with mounting screws and anchors, two
mounting templates (wall and ceiling), one ceiling bracket (optional), and two
ground straps (one 3-hole and one 4-hole) for the iDEN RadioBlades.
and ceiling mounts. The RFU is shipped with mounting screws and anchors, two
mounting templates (wall and ceiling), one ceiling bracket (optional), and two
ground straps (one 3-hole and one 4-hole) for the iDEN RadioBlades.
First, mount an RFU, then connect it to the ACU and verify that the RFU is
receiving power from the ACU. Next, insert the RadioBlades into the RFU in the
configuration specified in the site documentation, and replace the front cover on
the RFU.
receiving power from the ACU. Next, insert the RadioBlades into the RFU in the
configuration specified in the site documentation, and replace the front cover on
the RFU.
4.4.1 Mounting
and
Anchoring
The RFU is to be installed on a wall or on or above the ceiling. The RFU is to be
fix-mounted on indoor permanent structures providing a separation distance of at
least 8 inches (20 cm) from all persons during normal operation and 10 feet
(3 meters) from other RFU mounted assemblies.
fix-mounted on indoor permanent structures providing a separation distance of at
least 8 inches (20 cm) from all persons during normal operation and 10 feet
(3 meters) from other RFU mounted assemblies.
The RadioFrame Unit (RFU) is not intended for mounting to drop ceilings.
Mounting this unit to a drop ceiling voids any warranty, expressed, implied, or
otherwise. Mounting this unit to a drop ceiling voids any regulatory agency
approvals, including, but not limited to, Underwriters Laboratories (UL), Canadian
Standards Association (CSA), and the European Community (CE).
Mounting this unit to a drop ceiling voids any warranty, expressed, implied, or
otherwise. Mounting this unit to a drop ceiling voids any regulatory agency
approvals, including, but not limited to, Underwriters Laboratories (UL), Canadian
Standards Association (CSA), and the European Community (CE).
NOTE: Mounting the RFU directly to a drop ceiling is expressly forbidden by the
National Electric Code (NEC), National Fire Protection Association (NFPA), and
the Uniform Building Code (UBC). RadioFrame Networks is not liable for any
direct, indirect, special, incidental, or consequential damages arising out of
National Electric Code (NEC), National Fire Protection Association (NFPA), and
the Uniform Building Code (UBC). RadioFrame Networks is not liable for any
direct, indirect, special, incidental, or consequential damages arising out of