RadioFrame Networks Inc MCSERIES10 Manual De Usuario
MC-Series System Installation & Testing
System Configuration Changes
104
RadioFrame Networks, Inc.
5
Remove the following terminations from the rear of each RF shelf to be added to the
configuration:
configuration:
•
RF Shelf 2:Tx IN B and Rx OUT B
•
RF Shelf 3:Tx IN C and Rx OUT C
6
Reconnect the following RF cables:
Index
Part Number
From
To
Type
RF_2
820-0611-20
RF Shelf 2: Tx IN B
RBS 1: Tx B
RF cable
RF_5
820-0611-20
RF Shelf 2: Rx OUT B
RBS 1: Rx B
RF cable
RF_3
820-0611-20
RF Shelf 3: Tx IN C
RBS 1: Tx C
RF cable
RF_6
820-0611-20
RF Shelf 3: Rx OUT C
RBS 1: Rx C
RF cable
7
Reconnect terminations to RF Shelf 1:
Index
Part Number
To
Notes
T2
820-0609-00
RF Shelf 1: Tx IN B
If adding RF Shelf 2
T4
820-0609-00
RF Shelf 1: Rx OUT B
If adding RF Shelf 2
T3
820-0609-00
RF Shelf 1: Tx IN C
If adding RF Shelf 3
T5
820-0609-00
RF Shelf 1: Rx OUT C
If adding RF Shelf 3
8
Remove the dust caps (RFN P/N: 546-0005-00) from cables RF_15 and RF_16 (RF Shelf 2)
and/or RF_21, and RF_22 (RF Shelf 3).
and/or RF_21, and RF_22 (RF Shelf 3).
9
Remove the dust caps (RFN P/N: 546-0003-00) from TOR Tx 2 and Rx 2 (RF Shelf 2) and/or
TOR Tx 3 and Rx 3 (RF Shelf 3).
TOR Tx 3 and Rx 3 (RF Shelf 3).
10
Reconnect the following RF cables:
Index
Part Number
From
To
Type
RF_15
820-0610-30
RF Shelf 2: TX OUT
TOR: Tx 2
RF cable
RF_16
820-0610-30
RF Shelf 2: RX IN
TOR: Rx 2
RF cable
RF_21
820-0610-30
RF Shelf 3: TX OUT
TOR: Tx 3
RF cable
RF_22
820-0610-30
RF Shelf 3: RX IN
TOR: Rx 3
RF cable
11
If the new configuration is two sectors only, RF Shelf 3 remains in the rack and must remain
unpowered.
unpowered.
12
Push the new datafill load to the iSC.
13
Using the breakers on the PDU, turn up the BIC, AIC, and RBS 1 (RBS 2 and RBS 3 if
present), and then verify that the components are operational before proceeding.
present), and then verify that the components are operational before proceeding.
Wait approximately 3 minutes for the following indicators:
•
RBS: The STATUS LED for each group will light green in this order: A, B, and then C.
•
RBS: The RADIOBLADE STATUS LEDs will light red and then green for each present
RadioBlade. If no RB is present, the LED will not light. To verify the contents of the RBS,
pull out the shelf (powering off is not required) and inspect the RadioBlades and their
RadioBlade. If no RB is present, the LED will not light. To verify the contents of the RBS,
pull out the shelf (powering off is not required) and inspect the RadioBlades and their