SmartBridges Pte Ltd NEXUS2 Manual De Usuario
FCC ID PWG NEXUS2 14
Installation Manual
Figure2-4-9 Tower and Wall Mounting
The unit is shipped with a mounting bracket that is suitable to be attached to towers. To
mount the NEXUS on a pole, follow these steps:
mount the NEXUS on a pole, follow these steps:
Step 1 Attach the NEXUS unit to the square plate on the mounting bracket with the
supplied bolts.
Step 2 Find a suitable mounting location on the tower or wall. (If required, drill holes on
the wall corresponding to the mounting bracket holes.)
Step 3 Hoist the entire assembly to the mounting location.
Step 4 Attach the mounting arm assembly to the wall or to the tower pole using the
supplied U bolts, which fit 1.25 to 1.75 inch poles.
Step 5 Loosen the screws and adjust the vertical and horizontal alignment one at a time
to point towards the remote NEXUS unit.
Note Factory assembled smartBridges antennas are vertically polarized. Be sure to
mount the unit so that the antenna polarization matches the remote antenna
polarization. If it does not, remove the four bolts, rotate the parabolic dish 90
degrees and reattach.
polarization. If it does not, remove the four bolts, rotate the parabolic dish 90
degrees and reattach.
2.8 Wireless LAN installation guide lines and Authorization for use
Installation and use of this Wireless LAN device must be in strict accordance with the
instructions included in the user documentation provided with the product. Any changes
or modifications made to this device that are not expressly approved by smartBridges
may void the user’s authority to operate the equipment. smartBridges is not responsible
for any radio or television interference caused by unauthorized modification of this
device, or the substitution or attachment of connecting cables and equipment other than
specified. It is the responsibility of the user to correct any interference caused by such
unauthorized modification, substitution or attachment. smartBridges and its authorized
resellers or distributors will assume no liability for any damage or violation of
government regulations arising from failing to comply with these guidelines.
The use of Wireless LAN devices may be restricted in some situations or environments
for example:
* On board of airplanes, or
* In an explosive environment, or
* In case the interference risk to other devices or services is perceived or
identified as harmful.
In case the policy regarding the use of Wireless LAN devices in specific organizations or
environments (e.g. airports, hospitals, chemical/oil/gas industrial plants, private buildings
etc.) is not clear, please first verify authorization to use these devices prior to operating
the equipment.
2.9 Label fixing
The installer who is installing the SB 3001 module inside Nexus 3010 should
instructions included in the user documentation provided with the product. Any changes
or modifications made to this device that are not expressly approved by smartBridges
may void the user’s authority to operate the equipment. smartBridges is not responsible
for any radio or television interference caused by unauthorized modification of this
device, or the substitution or attachment of connecting cables and equipment other than
specified. It is the responsibility of the user to correct any interference caused by such
unauthorized modification, substitution or attachment. smartBridges and its authorized
resellers or distributors will assume no liability for any damage or violation of
government regulations arising from failing to comply with these guidelines.
The use of Wireless LAN devices may be restricted in some situations or environments
for example:
* On board of airplanes, or
* In an explosive environment, or
* In case the interference risk to other devices or services is perceived or
identified as harmful.
In case the policy regarding the use of Wireless LAN devices in specific organizations or
environments (e.g. airports, hospitals, chemical/oil/gas industrial plants, private buildings
etc.) is not clear, please first verify authorization to use these devices prior to operating
the equipment.
2.9 Label fixing
The installer who is installing the SB 3001 module inside Nexus 3010 should