SmartBridges Pte Ltd SPEEDTRAP2 Manual De Usuario
airPoint XO Series
Page 10 of 24
Select the most appropriate place on the roof which will provide a direct
view to the Access Point. Secure a 1.5 inch steel pipe vertically and insure
that it cannot come off with wind force. Attach the bracket of the airPoint
XO™ or XO
view to the Access Point. Secure a 1.5 inch steel pipe vertically and insure
that it cannot come off with wind force. Attach the bracket of the airPoint
XO™ or XO
2
™ unit with the 2pcs of U bolts to the pipe. Make sure to
tighten both top and bottom mounting plates to the pipe with U bolts, nuts
and spring washers. Tighten the nuts so that the bracket does not rotate
on the pipe. The mounting should be such that the antenna socket, LED's,
Ethernet cable outlet face downward.
and spring washers. Tighten the nuts so that the bracket does not rotate
on the pipe. The mounting should be such that the antenna socket, LED's,
Ethernet cable outlet face downward.
Note:
1.
Do not mount the unit upside down with RF connectors facing up.
2.
There are no user adjustable parts inside and it is recommended
that the unit is used in the same way it is shipped.
that the unit is used in the same way it is shipped.
3.
Make sure that the unit is mechanically well secured to the
mounting tower, pole, mast or wall.
mounting tower, pole, mast or wall.
4.
Radio communications requires Radio Line of Sight (RLOS) or
Visual Line of Sight. Therefore, it is essential that the antennas
connected to the airPoint XO™ or XO
Visual Line of Sight. Therefore, it is essential that the antennas
connected to the airPoint XO™ or XO
2
™ and the Access Point
Clients, are in line of sight without any obstruction.
4.2 Mounting the Antenna
Antenna should be mounted on the same pipe as the airPoint XO™ or
XO
XO
2
™ and positioned above it. The height of the antenna and direction
should be in the direction of the Client devices. The antenna socket of the
airPoint XO™ or XO
airPoint XO™ or XO
2
™ and the antenna input have to be connected by an
RG 8 N Male to N Male cable.
Note:
1.
Use a low loss coaxial cable, such as LMR400 (times microwave),
with not more than a 2 meter length connecting the device to the
antenna.
with not more than a 2 meter length connecting the device to the
antenna.
2.
Use good quality N (male) connectors on the coaxial cable from
sources such an Amphenol.
sources such an Amphenol.