CDVI WIRELESS S.P.A. DS433 Manual De Usuario

06

78

The radiocontrol ERONE DS433 has been designed for the 
control of automatic closing systems and anti-burglar 
systems. The operating frequency is among the European 
harmonised frequencies; the product fully complies with 
the European Regulations  89/336/CEE, 73/23/CEE , 
99/05/CE. The receiver which makes the activation, once 
received the transmitter code, has to be connected during 
the installation  to the device to control ( gate, garage door, 
rolling shutters, awnings, anti-burglar appliances, lighting 
). The transmitter security code is obtained by means of a 9 
ways three-state dip-switch which allows up to 19683 code 
combinations. All the receivers of the range Erone DS433 
can store into the EEPROM the code of many transmitters. 
Each transmitter ( or its different keys ) can be stored into 
different receivers and hence can do more functions. 
In order to use the unused keys of the transmitter it is 
enough to connect the dedicated receiver to the 
mechanism to drive ( i.e. electrolock of a pedestrian gate, a 
buzzer, etc. ) and proceede to store the keys on its memory.  

Number of keys

 :

        2 or 4

Supply :

      12 Vdc

Battery duration:

 from 12 to 24 months

Battery type:

           23A

Current consumption :

 

       25 mA

Operating frequency :

              433.92 MHz

Security code combinations number:

       19683

Modulation:

     AM/ASK

E.r.p. :

              50 - 100 uW

Range in open space :

     from 100 to 200 m

Operating temperature :

from -10 °C to +55 °C

Dimensions :

        83 x 48 x 16 mm

Weight :

          40 g

Open the rotating door to access to the battery and the 
dip-switches.The dip-position will give the security code. 
Warning: Each transmitter is provided with the same code 
set on the dip-switches; it highly advisable to change this 
code by moving the dip-switches on the favourite position 
( “+”, “0” , “-”).

The transmitter code has to be stored into the receiver 
memory. The memorisation can be done by selflearning. 
The instructions for this operation are reported on the 
receiver installation manual. Your own installer will 
perform this operation during the installation or will give 
you the necessaries explications during the selling.
Don’t forget that the still free buttons of your transmitter 
can be used for further wireless fuctions.
Ask your installer the best suitable receiver.

The radio signal is not

verifiable

The transmitter led 

doesn't switch on 

The radio signal is not

verifiable

The transmitter led  

switches on 

The guarantee period of all Erone products is 24 months, 
beginning from the manufacturer date. During this 
period, if the product does not work correctly, due to a 
defective component, the product will be repaired or 
substituted at the discretion of the producer. The 
guarantee does not cover the plastic container integrity. 
After-sale service is supplied at the producer's factory.

ERONE is a trademark by ELPRO INNOTEK S.r.l.

Via Piave, 23 - I-31020 S.Pietro di Feletto (TV)

ITALY

Tel.: +39/0438/450879 - Fax.: +39/0438/457126

Toll-free number: 800.53.46.46

E-Mail: info@erone.com

Web: www.erone.com

Replace the transmitter 

battery

Check the power supply 

of the receiver 

Replace the transmitter 

battery

ERONE - Type : SETDS39433E2-E4 

FCC ID : PWJDS433

This device complies with 

FCC Rules 

Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and 
(2) this device must accept interference received, including 
interference that may cause undesired operation.

Part. 15 of the 

T H E  S M A R T  L I V I N G

Any changes or modification to ERONE equipment not expressly 
approved by ELPRO INNOTEK Spa  could void the user's authority 
to operate the equipment.

To access the battery slide out the battery door. Place the 23A alkaline 
battery between the 2 contacts.
Respect the right polarity as indicated on the bottom of the box.