CDVI WIRELESS S.P.A. S3RT Manual De Usuario
The Installer’s Choice
8 - BATTERY ACCESS
To access the battery slide out the battery door as shown
in figure. Slide out the 2 old batteries and replace them
with the new ones [CR2016] respecting the polarity, with
the positive (+) side upward.
NOTE: Please dispose of the batteries properly according
to local laws and regulations. Test proper battery instal-
lation by verifying that the LED illuminates when the
button is pushed.
4 - NUMBERING
Each transmitter is manufactured and sold with a diffe-
rent factory-set serial number.
6 - PROGRAMMING
The transmitter must be programmed into your system
memory.
7 - OPERATION
A - Firmly depress the button until the small red BLUE
illuminates.
B - After the LED has illuminated, release the button.
If the device you are attempting to activate does not re-
spond, repeat steps A and B or consult section 9
( Troubleshooting ) of this manual.
9 - TROUBLESHOOTING
PROBLEM
SOLUTION
The system does not receive the
transmitter signal.
The transmitter LED is ON
Check to verify if the remote
is programmed into your system
The operating range is reduced
The transmitter LED is blinking
Low battery : replace batteries
The system does responds.
The transmitter LED is OFF
Battery empty : replace batteries
5 - MAIN COMPONENTS
This device complies with Part. 15 of the FCC Rules
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept interference received, including inter-
ference that may cause undesired operation.
FCC ID : PWJS3RT
Notice
Any changes or modification to CDVI equipment not expressly
approved by CDVI could void the manufacturer’s warranty.
Button A
Button B
Button C
Button D
Battery door
2 x CR2016
Blue LED
Key ring
Slide to
open
CDVI 1637 Highway 440 West, Laval, Québec, Canada, H7L3W3
Tel: (450) 682-7945, Toll Free Tel: 1-866-610-0102,
Fax: (450) 682-9590, Toll Free Fax: 1-866-682-9590
Manufactured by:
CDVI Wireless
Made in ITALY
WARRANTY
The warranty period for this product is 60 months, beginning from
the manufacturer date. During this period, if the product does not
work correctly, due to a defective component, the product will be
repaired or substituted at our discretion. The guarantee does not
cover the plastic container integrity. After-sale service is supplied
at the factory.
IS-T15CDUK Rev. 0 15/1/2014
This EUT is in compliance with MPE for general population
/ uncontrolled exposure limits and it had been tested in
accordance with the measurement methods and procedures
specified in FCC 47 CFR § 1.1310 and 2.1091 .
To satisfy FCC RF exposure requirements for mobile transmitting devices,
a separation distance of 20 cm or more should be maintained between
the antenna of this device and persons during device operation. To ensure
compliance, operations at closer than this distance are not recommended.
The antenna used for this transmitter must not be co-located in conjunction
with any other antenna or transmitter.