Wilson Electronics LLC 2B1401SA Manual De Usuario

0

 Warning: 

Verify that both the outside antenna and the adapter extension cable are 

connected to the amplifier before powering up the amplifier.

 Warning: 

RF Safety: In-vehicle - The outside antenna must be installed with a 

separation of at least 20 inches from any of the vehicle’s occupants or 

nearby persons and must not be located or operating in conjunction with 

any other antenna or amplifier.  Use of a cellular amplifier with an antenna 

gain higher than 6.12 dBi is in violation of FCC regulations, for which the 

offender is fully liable.  All Wilson mobile antennas are 6.12 dBi or less.

 Warning: 

RF Safety: In-vehicle - All roof-mount antennas should be centrally 

located on the roof of the vehicle.  Glass-mount antennas should be 

located in the middle of either the front or back windshield.  Mirror-mount 

antennas should be at least six feet from the ground and at least 20 

inches from any persons in or around the vehicle.

 Warning: 

RF Safety: In-Building - The outside antenna must be installed on an 

outdoor permanent structure with a separation of at least 26 inches from 

all persons during normal operation. The outside building antenna must 

not have a gain that exceeds 15 dBi. All Wilson outside building antennas 

have gains of 15 dBi or less.

Lightning protection is recommended for all in-building installations.

NOTE: The aluminum casing of a Wilson amplifier will adjust very quickly to the ambient 

temperature of its environment. For example, in the summer, when the inside of a car can 

reach 140 degrees Fahrenheit, the amplifier temperature may be 150 degrees or higher. 

The casing will be hot to the touch, similar to a metal door handle or a steering wheel. Such 

high temperatures will not damage the amplifier, nor do they pose a fire risk to the vehicle. 

As recommended in these instructions, install the amplifier in a location with adequate 

ventilation, such as under the seat, in the trunk or under the dashboard.  Keep the area free 

of items that could block air flow to the amplifier.