Wilson Electronics LLC 2B2725 Manual De Usuario

General
Your Wilson Electronics Sleek has been carefully engineered to significantly improve the performance 

of your phone. Together with an Outside Antenna, the Sleek’s state-of-the-art circuitry is designed to 

increase your phone’s signal to and from the cell tower. The Sleek reduces disconnects and dropouts 

and increases data communication rates on 2G, 3G networks and 4G on some models.
How it Works
With the phone in the cradle and while using a wireless Bluetooth

 headset (or hands free device) the 

Outside Antenna collects the cell tower signal and sends it through its cable to the Sleek.  The signal 

is then boosted by the Sleek and sent to the phone. When the phone transmits, the signal is picked up 
wirelessly and boosted by the Sleek and transmitted back to the cell tower through the Outside Antenna.

DO NOT use phone covers that have chrome or any other metallic surface. It may block cellular signals

The Outside Antenna must be installed vertically.  

Antenna performance will be degraded if the 

antenna is not vertical.
The antenna cable is small yet strong enough that it 

may be shut in most vehicle doors without damaging 

the cable.

For a more professional-looking installation, run the 

antenna cable under the door seal.  Carefully pull 

down the door seal.  Run the cable under the seal 

and push the seal back into place.  This prevents 

constant wear and tear on the cable as the door 

opens and closes.  The antenna cable is small 

enough to easily tuck under the door seal or 

plastic molding.

1. Install the Outside Antenna
To receive the best cell signal, select a location for the Outside Antenna that is preferably in the center of 

the vehicle’s roof, 12 inches (30 cm) away from any other antennas, free of obstructions, and at least 6 

inches (15 cm) from the rear or side windows or sunroof.

signal to and  

from cell tower

Sleek w/phone

Sleek w/phone