Wilson Electronics LLC 2B5225 Manual De Usuario

3

1.  Clean the area where the bracket is to be mounted with the 

alcohol wipe provided. Allow to dry.

2.  Peel the backing to expose the adhesive and press the bracket 

onto the desired location in the vehicle. Note: be sure the tab is 
positioned vertically, not horizontally.

3.  Allow the adhesive to cure for 24 hours before you attach the 

U-Booster™.

4.  Once the cradle is attached, you can adjust the angle of the 

adhesive bracket by applying gentle pressure to the top or bottom 
of the U-Booster™. This option is designed to swivel when the 
knurled nut is loosened, for greater adjustability of the U-Booster™ 
viewing angle. To lock bracket into position tighten large nut.

This mount allows for adhesive mounting as well as more 
permanent screw mounting.  This option is designed to swivel 
when the knurled nut is loosened, for greater adjustability of the 
U-Booster™ viewing angle.  For adhesive mounting, follow steps 1, 
2 and 3 in option 1.

For screw mounting, use an ice pick or an awl to punch through 
the adhesive and expose the four screw holes in the bracket. You 
must provide the screws of an appropriate size for your particular 
application. Using the bracket as a template, mark the locations 
for the screws as shown, drill pilot holes, attach the bracket with 
adhesive, and tighten all screws.

2

To receive the best cell signal, select a location for the outside antenna that is preferably in the center of the vehicle’s 
roof, 12 inches away from any other antennas and free of obstructions, at least 8-12 inches from the rear or side 
windows or sunroof.

The outside antenna must be installed vertically.  Signal 
performance will be degraded if the antenna is not 
vertical.

The antenna cable is small yet strong enough that it may 
be shut in most vehicle doors without damaging the cable.

For a more professional-looking installation, the antenna 
cable may be run under the door seal.  Carefully pull down 
the door seal.  Run the cable under the seal and push 
the seal back into place.  This prevents constant wear 
and tear on the cable as the door opens and closes.  The 
antenna cable is small enough to easily tuck under the 
door seal or plastic molding.

Two mounting brackets are provided for attaching the U-Booster™ to your vehicle’s dash.  Choose the appropriate 
one for your application.  See bracket specifi c mounting options below.

Once you have installed your selected mount in the desired location, and waited 24 hours for adhesive to cure, attach 
the cradle by aligning the rectangular hole on its back with the tab on the mount, grasping the sides of the cradle, slide 
it downward approximately ¼ inch into place.