Wilson Electronics LLC 460002 Manual De Usuario
3
4
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Mon.- Fri. Hours: 7am to 6 pm MST.
Installing a Wilson Electronics Signal Booster
Warning: Do not install the Low-Profile Antenna within four
inches of metal . (Metal found inside the vehicle’s seat will not
affect the antenna’s performance .)
Signal Booster
Low-Profile
Antenna
Installing the Low-Profile Antenna
Warning: Do not plug in the DC power supply until the Outside
and Inside Antenna cables are attached to the Signal Booster .
!
!
Select a location to install the Signal Booster that is away
from excessive heat, direct sunlight, moisture and has proper
ventilation .
Run the cable from the Outside Antenna and attach it to the
Run the cable from the Outside Antenna and attach it to the
connector labeled “Outside Antenna” on the Signal Booster .
Attach the Low-Profile Antenna cable to the connector
Attach the Low-Profile Antenna cable to the connector
labeled “Inside Antenna” on the Signal Booster .
NOTE: The aluminum casing of a Wilson Signal Booster will adjust very quickly to the ambient
temperature of its environment. For example, in the summer, when the inside of a car can reach 140
degrees Fahrenheit, the Signal Booster temperature may be 150 degrees or higher. The casing will
be hot to the touch, similar to a metal door handle or a steering wheel. Such high temperatures will
not damage the Signal Booster, nor do they pose a fire risk to the vehicle. As recommended in these
instructions, install the Signal Booster in a location with adequate ventilation. Keep the area free of items
that could block air flow to the Signal Booster.
Connect the power cable from the DC plug-in power supply
to the Signal Booster marked “POWER” and insert the large
end into DC power socket (the vehicle power adapter outlet) .
The Signal Booster may remain on all the time . However,
The Signal Booster may remain on all the time . However,
leaving the Signal Booster on in a vehicle when it is not
running can discharge or drain the battery in a day or two .
Switch the power supply off when not in use .
A good option is to power the Signal Booster through the
A good option is to power the Signal Booster through the
ignition switch so the Signal Booster is turned on and off with
the vehicle .
An available option to do this with is the Hardwire Kit from
An available option to do this with is the Hardwire Kit from
Wilson Electronics (#859923) .
IMPORTANT:
Do not power up the Signal Booster unless
antenna cables are attached to Signal Booster .
ON/OFF SWITCH
6 V DC / POWER
Powering up a Wilson Electronics Signal Booster