Comba Telecom Ltd. RD-2020 Manual De Usuario

 
 

 

RD-2020 CDMA QI 

Copyright - refer to title page 

Page 18

ENU Status : 1-0-0 

 

 

 

•  Located on the rear of the equipment enclosure are protruding vertical cooling fins. 
•  The two outer fins are designed for mounting the equipment onto the mounting rack; each of these fins 

has steel threaded inserts already fitted. 

•  Partially thread the hex socket bolts onto the steel threaded inserts identified in the following drawing 

as: ‘1’ and ‘4’. 

•  Lift the equipment and position it over the mounting rack, such that the hex bolts rests in their 

designated locations on the mounting rack. 

•  Insert four more hex socket bolts ‘2’, ‘3’, ‘5’ and ‘6’ onto steel threaded insets to ensure the equipment 

is firmly mounted. 

•  Tighten all hex socket bolts to secure the equipment onto the mounting rack. 
 

M8x20 hex  bolt

3

2

1

5

4

6

 

Figure 8: Attaching the Equipment onto the Mounting Rack 

 
  

Comba recommends that every horizontal cable entry to the equipment forms a 'U' before its entry to the 
equipment. Water on the cable will drip down at the bottom of the loop and will not accumulate at the 
equipment connectors.