Comba Telecom Ltd. RD-8132 Manual De Usuario
USER MANUAL FOR RD-8132
RD-8132 QI
Copyright - refer to title page
Page 13
ENU Status : 1-0-0
Note: When CDMA modem is used, only SMS function is supported to retrieve alarm information and to
provide remote control.
The power and data cables have been factory-connected to the wireless modem. User needs to insert the
SIM / UIM card into the wireless modem.
To insert or replace the SIM / UIM card, locate and press down the recessed button (yellow) to eject the
SIM / UIM card carrier. Insert the SIM / UIM card and push back the carrier until it is latched in place.
provide remote control.
The power and data cables have been factory-connected to the wireless modem. User needs to insert the
SIM / UIM card into the wireless modem.
To insert or replace the SIM / UIM card, locate and press down the recessed button (yellow) to eject the
SIM / UIM card carrier. Insert the SIM / UIM card and push back the carrier until it is latched in place.
Figure 8: Wireless Modem
The LED indicator on the wireless modem displays the state of the modem:
z
LED OFF: equipment power off
z
LED ON: equipment power on, no SIM/ UIM card or no connection to antenna
z
LED flash slowly: equipment power on, in SMS mode
z
LED flash quickly: equipment power on, in data link mode
Note: Data link mode is dependent on service availability from service provider. If it is required, the
operator’s SIM card must be data-enabled (Circuit Switch Data).
operator’s SIM card must be data-enabled (Circuit Switch Data).
End of section