Netgear 12200195 Manual De Usuario
Getting Started
12
Powerline 500 WiFi Access Point (XWN5001)
Method B: Use the WPS Button for Wireless Setup
You can use this method if you have a wireless router, or modem router with a WPS (Wi-Fi
Protected Setup) button. The WPS button might be labeled WPS, or it could look similar to
Protected Setup) button. The WPS button might be labeled WPS, or it could look similar to
or
.
To use WPS to set up your Access Point wireless network:
1.
Push the WPS button on the wireless client.
2.
Push and hold the Security button on the wireless access point for about 2 seconds and release
it. The Wireless LED starts flashing
it. The Wireless LED starts flashing
.
When the Wireless LED stops flashing, the wireless pairing is done and the wireless device is
securely connected to the XWN5001 Wireless Access Point.
securely connected to the XWN5001 Wireless Access Point.
Note:
This method pairs the XWN5001 with your wireless client, and at the same
time secures the connection with a random passphrase
.
3.
Connect your wireless device to the XWN5001. Connect a laptop, table, or smart phone to the
XWN5001 WiFi access point to gain access to the Internet
XWN5001 WiFi access point to gain access to the Internet
.
a. Launch the application on your wireless client (laptop, tablet, or smart phone).
b. Refresh the WiFi network list to see the network SSID list.
c. Connect to the WiFi network SSID NETGEAR_EXT or the one you configured in
b. Refresh the WiFi network list to see the network SSID list.
c. Connect to the WiFi network SSID NETGEAR_EXT or the one you configured in
step
4
, Method A.