Check Point Software technologies Ltd 67897 Manual De Usuario
Page 27
Using the First Time Configuration Wizard
Configure Check Point 1100 Appliance with the First Time Configuration
Wizard.
Wizard.
During the wizard, click Quit to save the settings that have been configured
and close the wizard.
and close the wizard.
Note - In the First Time Configuration Wizard, you may not see all
the pages described in this guide. The pages that show in the
wizard depend on your Check Point 1100 Appliance model and the
options you select.
the pages described in this guide. The pages that show in the
wizard depend on your Check Point 1100 Appliance model and the
options you select.
Starting the First Time Configuration Wizard
To configure the Check Point 1100 Appliance for the first time after you
complete the hardware setup, you use the First Time Configuration Wizard.
complete the hardware setup, you use the First Time Configuration Wizard.
If you do not complete the wizard, the wizard will run again the next time you
connect to the appliance. This can occur if one of these conditions applies:
connect to the appliance. This can occur if one of these conditions applies:
x
You have not completed the wizard.
x
The browser window is closed.
x
The appliance is restarted while you run the wizard.
x
There is no activity for a predefined amount of time (the default is 10
minutes).
minutes).
Note - After you complete the wizard, you can use the WebUI
(Web User Interface) to change settings configured with the First
Time Configuration Wizard and to configure advanced settings.
(Web User Interface) to change settings configured with the First
Time Configuration Wizard and to configure advanced settings.
To open the WebUI, enter one of these addresses in the browser:
x http://my.firewall
x http://192.168.1.1
If a security warning message is shown, confirm it and continue.
For more details, see Appendix A: Browser Security Warnings (on
page
For more details, see Appendix A: Browser Security Warnings (on
page
59
).
CP_1100Appliance_GettingStartedG27 27
CP_1100Appliance_GettingStartedG27 27
25/02/2013 10:05:30
25/02/2013 10:05:30