WebGate Inc. WB106X-WG1K Manual De Usuario
WebEye B106
WebEye B106 User’s Guide
30
(7) FTP event configuration
Administrator may set sending conditions, image resolution, and file name. Image resolution, filename, and
sending conditions setting methods for FTP are same as that of e-mail.
9) Pan/Tilt/Zoom Configuration
This page is to decide whether to use
pan/tilt/zoom control function or not and
select which serial port to use.
(1) Video Channel Selection
Administrator selects a video channel for
the pan/tilt/zoom mechanism. The four
the pan/tilt/zoom mechanism. The four
channels shown in the panel are the same
as seen on ‘Video Configuration’ page.
(2) Pan Tilt Function
Administrator defines whether to utilize pan/tilt control function or not.
(3) Zoom Function
Administrator defines whether to utilize zoom control function or not.
(4) Pan Reverse Mode Function
This is to set command reverse direction against to right and left direction control arrows. This function is
useful when PT driver is installed upside down.
(5) Tilt Reverse Mode Function
This is to set command reverse direction against to up and down direction control arrows. This function is
useful when PT driver is installed upside down.
(6) Select Serial Port
It is to select a useable serial p ort as the character of pan/tilt/zoom control receiver.
It is to select a serial port between ‘Serial #1’ and ‘Serial #2 ’ with which a pan/tilt/zoom control receiver is
connected to WebEye. Serial #1 is RS232C interface and Serial #2 is RS422/RS485 interface.
(7) Serial Port Base Address
This menu identifies the base address for a video channel and a pan/tilt/zoom (P/T/Z) control receiver.
WebEye B106 can support up to six P/T/Z devices for six separate channels when Serial #2 (RS485
Half-Duplex) is enabled. The “Serial Port Base Address” identifies each P/T/Z device to each channel. Select
Half-Duplex) is enabled. The “Serial Port Base Address” identifies each P/T/Z device to each channel. Select
a channel to configure and change the “Serial Port Base Address” to correspond with the channel number.
10) Serial Port Configuration
This page is to select a communication protocol
among listed ones or to set control parameters
manually for each serial port.
(1) Serial Port Selection