AeroScout TAG3500 Manual De Usuario

Descargar
Página de 20
     
Tag Mounting | 9 
No Flange 
The T3-BD tag can also be supplied without flanges. The tag can be fixed 
on a surface by applying adhesive on its back or using Velcro or double-
sided tape. It can also be placed into a sleeve. 
 
Figure 4. AeroScout T3-BD tag without flange 
Note the following: 
  Avoid putting glue on the battery cover or the tamper switch hole. 
  Apply 1x1’’ Velcro or double-sided tape patches as shown in Figure 
5.  
 
Figure 5. 1x1’’ Velcro or double-sided tape patches 
  However, the tamper switch cannot work if covered by the 1x1’’ 
Velcro/double sided tape patches. Therefore, in this case it is 
recommended to use glue or a thin tape and avoid covering the 
tamper switch area. 
Cradle 
The AeroScout T3-BD tag cradle can be used to incorporate the tag in 
existing equipment. The cradle is fixed on the asset (e.g. a machine) and the 
tag is snapped into the cradle. With the cradle, tags can be easily removed 
and replaced without the need to handle screws of adhesives.