CipherLab Co. Ltd. 1862 Manual De Usuario

 

 

51

 

 

 

Chapter 2

   Communication Interface 

 

2.4 BLUETOOTH

®

 SPP MASTER 

As a SPP master device, RFID Reader will be able to resume connection with the host 

computer upon powering on again, as long as the host application is running. If RFID 
Reader fails to resume connection, it will try every 5 seconds to re-connect to the host 

computer unless you issue the “#@bt_reset” or “#@sys_ldstbl=” command. 

For Bluetooth

®

 SPP Master Connection, refer to 

Note:  In SPP Master Mode, RFID Reader has to connect within the specified period of time 

(2 minutes by default). During the connection, the RFID Reader will enter Power 

Saving Mode. It will automatically power off when the Auto Shutdown time is 
reached. Refer to 

2.4.1 ACTIVATE BLUETOOTH

®

 SPP MASTER MODE 

How to connect with the target machine? 

Two parameters are necessary using “#@bt_target=” command for SPP Master connection. One is 

to configure connection type as SPP Master; the other is MAC ID of the target machine. 

 

#@bt_target?\r  

Purpose Get 

®

 Target Machine 

Response OK,[m],[n]\r 

[m]: Bluetooth

®

 Type, ‘0’ – SPP Master, ‘1’ – 3610 

[n]: MACID of target Machine or S/N of 3610 

ERR,[code]\r 

#@bt_target=[m],[n]\r  

Purpose Set 

®

 Target Machine 

Response OK 

ERR,[code] 

 

Exit SPP Master Mode 

To stop such re-connection, you can issue the “#@bt_reset” command so that the current 
connection record (= MAC ID) will be cleared. Connection type will also be restored to default (SPP 

Slave). Go through the whole process in 

 to establish a new WPAN 

connection.