CipherLab Co. Ltd. 2564 Manual De Usuario
206
Enter Setup
2564MR Barcode Scanner
User Guide
79 (y)
Chinese 25
5A (Z)
N/A
7A (z)
Aztec
5B ( [ )
GS1 DataBar (RSS)
7B ({)
Micro QR
7C (|)
USPS 4CB / One Code /
Intelligent Mail
Intelligent Mail
7D (})
UPU FICS Postal
7E (~)
UCC Coupon Extended Code
3) Barcode Length setting – read the “
Decimal Value
” barcode on page 263 for the 4-digit
length of the (first) barcode. For example, read “0065” for barcode length of 65
characters or read “0000” for any length.
characters or read “0000” for any length.
Note: If not reading 0000 for any length, the 4-digit length must exclude prefix, suffix
(0x0d by default), length code, etc.
4) Matching Character setting – read the “
Hexadecimal Value
” barcode on page 264 for the
1
st
character that must be found matching in the (first) barcode. For example, read “4”
and “1” for matching character “A” as the first character in the barcode or read “00” for
any character.
5) Read twice the “F” barcode on page 264 (“FF”) to complete the setting of each barcode.
6) Read the “Validate” barcode to end the editing of the barcode set.
6) Read the “Validate” barcode to end the editing of the barcode set.
5.6.2 ACTIVATE THE CONCATENATION OF BARCODES
By default, the output sequence editing of the concatenation of barcodes is not applied.
When “Enforce Output Sequence” is enabled, all barcodes read by the scanner must meet
When “Enforce Output Sequence” is enabled, all barcodes read by the scanner must meet
with the criteria for the concatenation. If data is found excluded from all output sequence
sets (= not meeting with the criteria), the scanner will not accept the reading, and therefore,
data will not be transmitted.
When “Apply Output Sequence” is enabled, only barcodes found meeting with the criteria
are counted for the concatenation. Those found not meeting with the criteria are processed
sets (= not meeting with the criteria), the scanner will not accept the reading, and therefore,
data will not be transmitted.
When “Apply Output Sequence” is enabled, only barcodes found meeting with the criteria
are counted for the concatenation. Those found not meeting with the criteria are processed
normally and individually.
Note: When it requires reading more barcodes to complete the “output sequence”
requirements, the scanner will respond with one short beep (low tone). After reading
an acceptable barcode, its LED indicator will become solid green and go off quickly (=
an acceptable barcode, its LED indicator will become solid green and go off quickly (=
Good
Read).
Upon
completion
of reading acceptable barcodes, the scanner will respond with one short beep (high
tone) and its LED indicator will become solid green and go off quickly (= Good Read).
tone) and its LED indicator will become solid green and go off quickly (= Good Read).