CipherLab Co. Ltd. 9700 Manual De Usuario

81

Chapter 3 Radios

Maximum 

In Max Power Savings (Max PSP) mode, the 
access point buffers incoming messages for 
the radio, which wakes up periodically and 
connects to the access point to see if any 
buffered messages are waiting. The radio 
requests buffered messages and then goes 
back to sleep. It conserves the most power 
but offers the lowest throughput. It is 
recommended when battery power is in 
use.

Fast 

Power Save Mode (Fast PSP) switches 
between the two modes described above, 
depending on network traffic. This mode 
switches to CAM when retrieving a large 
number of packets and switches back to 
PSP (= Power Save Polling) after the 
packets have been retrieved. It is 
recommended when power consumption is 
a concern but you need greater throughput 
than that allowed by Max PSP. 

Default: Fast 

Bit Rate 

The measurement of how much data is transmitted in a given 
amount of time from one location to another. 

Value: Auto (rate is negotiated automatically with the AP)   

Default: Auto 

Radio 

Mode 

Use of 802.11a/b/g/n frequencies and data rates when 
interacting with an AP, or the use of ad hoc to associate to a 
station radio.   

Value: B rates only, BG rates full, G rates only, BG LRS, A 

rates only, ABG rates full, BGA rates full, Ad Hoc 

B rates 
only 

1, 2, 5.5, and 11 Mbps. 

BG rates 
full

All B and G rates, plus N rates if supported.

G rates 
only  

6, 9, 12, 18, 24, 36, 48, and 54 Mbps. 

BG LRS 

1, 2, 5.5, 6, 11, 24, 36, and 54 Mbps. This 
should only be used with Cisco APs running 
IOS in autonomous mode (without 
controllers).  

A rates 
only 

6, 9, 12, 18, 24, 36, 48, and 54 Mbps, plus 
N rates if supported. 

ABG rates 
full

All A rates and all B and G rates, with A 
rates (the 802.11a radio) preferred, plus N 
if supported. 

BGA rates 
full

All B and G rates and all A rates, with B and 
G rates (the .11g radio) preferred, plus N 
rates if supported.