The Watt Stopper Inc. TDPGIN Manual De Usuario
Go!
Use!
Figure 3
1. Press × momentarily to fade the circuit to
its last-used level – press twice for full
bright
2. Press and hold × to increase the present
level
3. Press Ø momentarily to fade the circuit to
OFF
4. Press and hold Ø to decrease the
present level
IMPORTANT – Air Gap Isolation: to isolate
the load for relamping, unplug the light fixture
from the lamp module outlet.
Advanced Operation
Groups
Now, the lamp module is controlled from the wall switch location,
just like a permanently installed dimmer.
Figure 4
Chances are, your lamp module ended up
behind the sofa – not a great place to be
setting light levels!
You can elegantly solve this problem by
You can elegantly solve this problem by
grouping the lamp module with a wireless
Miro
TM
remote switch (it looks exactly like a
wireless Miro
TM
dimmer), mounted at a
conventional wall-switch location. You could
use one or more remote switches in a group
with your lamp module, giving you fingertip
control from, say, each entrance to a room.
After installing the remote switch(es) and
After installing the remote switch(es) and
configuring a house ID (see above), Group
devices must be bound together:
1. Go to any Group device and press Ú for
2 seconds. The status LED starts flashing
yellow, and all other devices in the house
start flashing green.
2. Go to each of the other devices to be
bound into the Group and press Ú for 2
seconds on each one. Their LEDs will
start flashing yellow, indicating that they
have joined the Group (made a mistake?
Press Ú for 2 seconds a second time to
deselect from the Group).
3. Return to the first device and press Ú for
2 seconds to terminate Group binding. All
LEDs revert to green. Now, all the
devices in the Group control the load
circuit, in exactly the same manner.
3, 4
1, 2
1, 3
wireless Miro
TM
remote switch
mounted at a
conventional light
switch location
mounted at a
conventional light
switch location
2
wireless Miro
TM
plug-in lamp
module