OPISYS USHR-800NI Manual De Usuario
5
1.3 Description
This product is designed for offices, hotel rooms, small parking lots, garages or
small buildings, helping to improve 806 ~ 866 MHz communications signal and
coverage by extending the coverage of a base station.
Outdoor antenna receives signal between 806 MHz and 821 MHz , then USHR-
800NI amplifier amplifies the signal. After amplification, the signal is passed
through to the indoor antennas. Conversely, signals from handsets are amplified
and retransmitted to the base station.
2. Installation
2.1 Introduction
This section provides information for the installation and setup of the USHR-800NI
amplifier. The information consists of procedures for unpacking, inspection and
preparation for the installation, as well as the actual installation and the setup.
amplifier. The information consists of procedures for unpacking, inspection and
preparation for the installation, as well as the actual installation and the setup.
2.2 Unpacking
and
Inspection
Examine the shipping carton for damage before unpacking the unit. If the shipping
carton is damaged, try to have the carrier’s agent present when the equipment is
unpacked. If visual inspection reveals physical damage(s) to the equipment, you
should send it back for replacement.
carton is damaged, try to have the carrier’s agent present when the equipment is
unpacked. If visual inspection reveals physical damage(s) to the equipment, you
should send it back for replacement.
Verify that the equipment is complete, as listed under packing slip. Contact
OPISYS with any missing component.
OPISYS with any missing component.
2.3 Preparation for Use
2.3.1 Power Requirements
The power supply of the USHR-800NI accepts 5.1 VDC. Power consumption of
the USHR-800NI is approximately 2.6 Watts.
the USHR-800NI is approximately 2.6 Watts.
2.3.2 Operating Environment
The USHR-800NI is intended for indoor use only. Do not install it where it might
be exposed to the outside elements as this could result in destruction of the unit and
other hazards.
For normal operations, the environmental conditions should be as follow:
be exposed to the outside elements as this could result in destruction of the unit and
other hazards.
For normal operations, the environmental conditions should be as follow:
Temperature range:
–20
°C to 50 °C, Maximum Humidity: 95 %