Linksys HGA5T-4 Manual De Usuario
5
Chapter 3: Getting to Know the
Wireless-B Access Point
Wireless-B Access Point
The Access Point’s ports and Reset button are located on the Access Point’s rear
panel.
panel.
Reset Button
There are two ways to reset the Access Point’s factory
defaults. Briefly press the Reset Button for approximately
ten seconds, or use the Password tab of the Access Point’s
Web-based Utility.
defaults. Briefly press the Reset Button for approximately
ten seconds, or use the Password tab of the Access Point’s
Web-based Utility.
LAN
This LAN (Local Area Network) port connects to
Ethernet network devices, such as a hub, switch, or
router.
Ethernet network devices, such as a hub, switch, or
router.
Power
The Power port is where you will connect the power
adapter.
adapter.
4
T
Power
Red. The Power LED lights up when the Access Point is
powered on.
powered on.
Act
Green. If the Act LED is flickering, the Access Point is
actively sending or receiving data to or from one of the
devices on the wireless network.
actively sending or receiving data to or from one of the
devices on the wireless network.
Link
Orange. The Link LED serves two purposes. If the LED is
continuously lit up, the Access Point is successfully connect-
ed to a device through the LAN port. If the LED is flicker-
ing, it is an indication of any wired network activity.
continuously lit up, the Access Point is successfully connect-
ed to a device through the LAN port. If the LED is flicker-
ing, it is an indication of any wired network activity.
The Wireless-B Access Point’s LEDs
Figure 3-2
The Wireless-B Access Point’s Ports
Figure 3-1
Important: Resetting the Access Point will erase all of your settings
(WEP Encryption, Wireless, and LAN settings, etc.) and replace
them with the factory defaults.
(WEP Encryption, Wireless, and LAN settings, etc.) and replace
them with the factory defaults.