Linksys HGA9NWAP54GPE Manual De Usuario

58

Appendix H: Regulatory Information

FCC STATEMENT

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not 
installed and used according to the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which is found by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna                                                                                                                                                                                                                                                                                

Increase the separation between the equipment or devices

Connect the equipment to an outlet other than the receiver's

Consult a dealer or an experienced radio/TV technician for assistance

 

INDUSTRY CANADA (CANADA)

EC DECLARATION OF CONFORMITY (EUROPE)

Linksys declares that this product conforms to the specifications listed below, following the provisions of the 
European R&TTE directive 1999/5/EC: 

EN 301 489-1, 301 489-17 General EMC requirements for Radio equipment.

EN 609 50 Safety

This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) This device may not cause harmful 

interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by 

the party responsible for compliance could void the user's authority to 
operate this equipment.

The availability of some specific channels and/or operational frequency 
bands are country dependent and are firmware programmed at the 

factory to match the intended destination. The firmware setting is not 
accessible by the end user.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment 
should be installed and operated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Operation is subject to the following two conditions: 1) This device may not cause interference and  2) This device must 
accept any interference, including interference that may cause undesired operation of the device.

This device has been designed to operate with an antenna having a maximum gain of 9 dBi. Antenna having a higher 
gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms. 

Règlement d’Industry Canada 

Les conditions de fonctionnement sont sujettes à deux conditions:

1)•Ce périphérique ne doit pas causer d’interférence et.

2)•Ce périphérique doit accepter toute interférence, y compris les interférences 

pouvant perturber le bon fonctionnement de ce périphérique.

•IMPORTANT NOTE:

•Radiation Exposure Statement:

•This equipment complies with IC radiation exposure limits set forth for an 

uncontrolled environment. This equipment should be installed and operated with 

minimum distance 20cm between the radiator & your body.