Linksys Wireless-G USB Network Adapter with RangeBooster Manual De Usuario

9

 1. Connect one end of the included USB cable to the Adapter’s USB port.

 2. Connect the other end of the cable to one of the USB ports on your computer.

 3. The Power LED should light up when the Adapter is plugged in.

4. Raise the antenna. Make sure the antenna points straight up into the air, at a 90º angle from the Adapter. This 

will ensure optimum wireless operating range and performance. 

The next screen to appear will be the Available Wireless Network screen.

This screen provides two options for setting up the Adapter.

•

Available Wireless Network. (For most users.) Use this option if you already have a network set up. The 
networks available to this Adapter will be listed on this screen. You can choose one of these networks and 
click the Connect button to connect to it. Click the Refresh button to update the Available Wireless Network 
list. 

•

Manual Setup. If your network is not listed on this screen, select Manual Setup to set up the adapter 
manually. This method of setting up the Adapter is intended for Advanced Users only.

The setup for each option is described, step by step, under the appropriate heading on the following pages.

Click Exit to close the Setup Wizard, if you wish to set up the Adapter later.

Available Wireless Network

The available networks are listed in the table on the center of the screen by SSID. Select the wireless network you 
wish to connect to and click the Connect button. (If you do not see your network listed, you can click the Refresh 
button to bring the list up again.) If the network utilizes wireless security, you will need to configure security on 
the Adapter. If not, you will be taken directly to the Congratulations screen.

1. If you have wireless security enabled on your network, continue to step 2. If you don’t have wireless security 

enabled, continue to step 3.