Hewlett Packard Enterprise Company APIN0318 Manual De Usuario

| Installation Guide

6. Move the clip towards the gland body, passing over the grommet, until the wavy end of the clip properly fits 

into the wavy end of the gland body.

7. Screw the sealing nut onto the gland body

To connect the fiber-optic cable to the access point, perform the following steps.
1. Remove the dust cap from the SFP port.
2. Insert the SFP module into the SFP port, and ensure it in place.
3. Slide the sealing nut, clip, split grommet and gland body over the cable.

4. Insert the optic fiber connector of the cable into the SFP module.
5.  Screw the gland body onto the SFP port

Two grommets are provided in the package for use with the Ethernet cables. One is applicable for cables with 
4-6 mm diameter, and another is applicable for cables with 6-10 mm diameter.

The fiber-optic cable is not included in the package and must be purchased separately. Purchase a suitable UV-
resistant, outdoor rated cable for use with the access point.

When the fiber-optic cable (with the cable gland) is connected to the access point, the AP-270-MNT-H2 mount 
kit is not applicable for mounting the access point. 

When using the AP-270-MNT-H1 mount kit, the access point with the fiber-optic cable (with the cable gland) 
connected can only tilt down 30 degree in maximum.

Sealing Nut

Clip

Gland Body

Split Grommet