Hewlett Packard Enterprise Company ARUBA70 Manual De Usuario

Appendix B

If properly set up, the AP support prompt can be accessed remotely using Telnet. By default, 
this feature is turned off for security purposes and cannot be turned on using the AP interface.

Setting Telnet Access

Telnet access can only be changed from the WLAN switch management interface. Log in to 
the WLAN switch CLI using the 

admin account, access the configuration (config) 

prompt, and issue the following commands:

Using Telnet to Connect

Use a Telnet client on your management workstation to connect to the Aruba 70’s individual 
IP address. The connection command may vary depending on the specific software used, but 
commonly appears as follows:

When the connection is established, the AP support prompt (

#) will be displayed.

(Aruba 5000) (config) # ap location <building>.<floor>.<device>
(Aruba 5000) (sap-config location b.f.d) # telnet {enable|disable}

> telnet <Aruba 70 IP address>