Bioscrypt Inc. VSTICLASS Manual De Usuario

Document #430-90003-08

© Copyright 2003, Bioscrypt Inc.  All rights reserved.

The readers can be mounted to any flat surface.  The

following describes the V-Prox/V-Flex/V-Pass mounting,

but the same concept applies to mounting the V-Smart

and V-Station (except for mullion mounting).
The mounting plate is 2 inches wide, which is suitable

for mounting in a door mullion.  The mounting plate

hole pattern is also compatible with single gang box

mounting. The pig-tail protruding from the rear of the

unit is for connecting the reader to the rest of the

system.
Factors in determining the position of the reader on the

wall should include mounting in-line with other switch

plates or fixtures, approximately 54 inches from floor to

top of unit (see figure 4), mounted on knob-side of door, and in accordance with

Americans with Disabilities Act.

Reader mounting is very simple.  The mounting

plate is attached to the wall or mullion using screws

and anchors to secure it in place (see figure  4).

The reader body has two tabs which slide into the

wall plate.  Use the following procedure:

1.  Align reader body with wall plate
2.  Slide reader body down, locking tabs into

wall plate

3.  Set reader body in place with Phillips-head

#4-40 screw

4.  Attach Aux. port door to bottom of reader

with a twisting motion

5.  Secure door to reader with pin-in-hex #6-32

screw

All of the readers in the Veri-Series line are

constructed out of durable ABS plastic.  The mounting plate is also constructed

out of ABS plastic.  This system provides for a very lightweight, yet sturdy system.

 

48 – 54” 

1

2

5

4

3