Chi Mei Communication Systems Inc. 0303BEN01 Manual De Usuario

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-

tions: (1) this device may not cause harmful interference, and (2) this device must accept any interfer-

ence received, including interference that may cause undesired operation.
FCC ID: QDJ-0303BEN01
Statement according to FCC part 15.21
Modifications not expressly approved by this company could void the user's authority to operate the 

equipment.
Statement according to FCC part 15.105
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec-

tion against harmful interference in a residential installation. This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no guarantee that interference 

will not occur in a particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-

nected.

• Consult the dealer or an experienced radio/TV technician for help.

RF exposure 

Tests for SAR are conducted using standard operating positions specified by the FCC with the phone 

transmitting at its highest certified power level in all tested frequency bands. Although the SAR is 

determined at the highest certified power level, the actual SAR level of the phone while operation can 

be well below the maximum value. This is because the phone is designed to operate at multiple power 

levels so as to use only the power required to reach the network. In general, the closer you are to a 

wireless base station antenna, the lower the power output. 
Before a phone model is available for sale to the public, it must be tested and certified to the FCC that 

it does not exceed the limit established by the government-adopted requirement for safe exposure. The 

tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by 

the FCC for each model. (Body-worn measurements may differ among phone models, depending 

upon available accessories and FCC requirements). While there may be differences between the SAR