CommScope Technologies LLC S1000C Manual De Usuario
Chapter 2
Getting Started
2-8
913114 1.5.01 August 2016
D
R
A
F
T
During boot-up the device’s green LED will be solid for a few seconds during initial
hardware tests. Upon completion of hardware tests, all LEDs, except the WAN LED,
will turn off until the software loads. This takes 1 to 2 seconds.
hardware tests. Upon completion of hardware tests, all LEDs, except the WAN LED,
will turn off until the software loads. This takes 1 to 2 seconds.
When the WAN, NET, GPS, LTE, and WIFI LEDs are solid green, your S1000C is
ready for data traffic.
ready for data traffic.
NOTE
On the 3G side, the LEDs will change color during the automated setup sequence.
This process may take up to 2 hours. When the CDMA, NET, GPS, and WAN
LEDs are solid green, your S1000C is ready for voice traffic.
This process may take up to 2 hours. When the CDMA, NET, GPS, and WAN
LEDs are solid green, your S1000C is ready for voice traffic.
NOTE
For a summary of LED status indicators, see
a complete description of LED states, see
WAN port is connected; IPSec
tunnel established and UP; GPS
Time Fix is available; LTE
service is UP; WiFi service is UP.
tunnel established and UP; GPS
Time Fix is available; LTE
service is UP; WiFi service is UP.
Table 2-1. 4G Data LED states during S1000C boot sequence (continued)
WAN
NET
GPS
LTE
WiFi
S1000C State