CommScope Technologies LLC S1000C Manual De Usuario
Chapter 5
Troubleshooting
S1000C User Guide, Release 1.5
5-3
D
R
A
F
T
Resetting the S1000C
The S1000C has 2 reset buttons on the bottom of the unit.
If your S1000C operates properly for an extended period and the WAN LED on the
4G side of the device suddenly starts blinking red, the S1000 may have a problem
requiring a reset. To reset the S1000 board, push the Reset button for at least 10
seconds.
4G side of the device suddenly starts blinking red, the S1000 may have a problem
requiring a reset. To reset the S1000 board, push the Reset button for at least 10
seconds.
If the WAN LED on the 3G side starts blinking red, the CFAP may have a problem
requiring a reset. To reset the C4500 board, push the Reset button for at least 10
seconds.
requiring a reset. To reset the C4500 board, push the Reset button for at least 10
seconds.
Figure 5-1.
Reset the C4500 board
Reset the S1000 board
Resetting the S1000C
After resetting, your S1000C goes through an automated setup sequence. During this
time, the device's green LEDs will be solid for a few seconds, and then all LEDs will
turn off until the software loads. The reset process may take 30-45 minutes.
time, the device's green LEDs will be solid for a few seconds, and then all LEDs will
turn off until the software loads. The reset process may take 30-45 minutes.
After resetting the S1000C, if the failure persists, contact Customer Care. See