CommScope Technologies LLC IPBTS-C30-1900 Manual De Usuario
Chapter 3
l
ipBTS C30 installation
Installing the chassis
3-4
910136 Rev01.00 Standard July 2007
Installing the chassis
Position the chassis in the main rack, or cabinet and use the supplied 1/4 in. screws to securely
attach the chassis to the rack.
attach the chassis to the rack.
Unpacking and installing modules
All modules are tested and calibrated at the factory before being packed and shipped. Follow
the steps in this section to unpack, inspect, and install each component of the ipBTS.
the steps in this section to unpack, inspect, and install each component of the ipBTS.
WRIST STRAP
Use a wrist strap while performing the procedures documented in this section to safely
discharge static electricity and prevent damage to the equipment.
discharge static electricity and prevent damage to the equipment.
Figure 3-2.
Wrist strap connection point
NOTE
All shelf interconnect cables are included with the shipment. Make the external cables like
power, ground, backhaul, GPS, and RF connections at the site.
power, ground, backhaul, GPS, and RF connections at the site.
Connecting the ground
Ground the chassis by attaching the earth ground wire to the return bus as shown in
.
Attach wrist strap here
Chassis front