ConnecteDevice Limited BT3A Manual De Usuario
PAGE 3 / 6
BEFORE USING YOUR HEADSET FOR THE FIRST TIME
- You must charge it continuously for about 8 hours, until the red indicator light
turns off. Please refer to the “Charging the BLUETREK® E2” section of this
manual.
manual.
- Pair the headset with a mobile phone. Please refer to the “Pairing BLUETREK®
E2” section of this manual.
Introduction
The BLUETREK® E2 headset is a wireless headset based on the Bluetooth®
technology.
The BLUETREK® E2 headset has 3 buttons:
• “TALK “button (main button),
• 1 “VOL+ “button,
• 1
“VOL-
“button.
Charging the BLUETREK® E2
Please connect the charger to the headset and to the mains. During the charge, the
indicator light is red during a normal charge. The indicator light will turn off when the
charge is complete. During subsequent charges, the charging should take
approximately 2 hour 40 minutes.
When the indicator light flashes in red, your headset needs to be recharged.
Important:
indicator light is red during a normal charge. The indicator light will turn off when the
charge is complete. During subsequent charges, the charging should take
approximately 2 hour 40 minutes.
When the indicator light flashes in red, your headset needs to be recharged.
Important:
• The headset cannot be operated while charging. To maximize battery capacity, it
is recommended to recharge your headset to full capacity only when the battery
is low, since a battery has a lifetime of about 500 charging cycles.
is low, since a battery has a lifetime of about 500 charging cycles.
• If you leave your headset battery empty for an extended period of time, it could
excessively discharge the battery. In this case, you may have to charge your
headset for 10 hours or more until the battery recovers and recharges completely.
headset for 10 hours or more until the battery recovers and recharges completely.
•
Only switch on the headset once the red indicator light turns off, indicating the
battery has fully recovered.
battery has fully recovered.
• Do not let the battery charger remain plugged in the headset for more than 24h.
• The use of any other charger will automatically suspend the warranty.
Pairing the BLUETREK® E2
Before using the BLUETREK® E2 headset, you must pair it with your Bluetooth® mobile
phone. Pairing is the process of linking 2 Bluetooth® devices, so that they can
communicate.
To initiate pairing: