Cascade Networks Inc. 5200UNII Manual De Usuario
SM User Manual Draft for Regulatory Review
Page 15 of 33
IF USING A 5.7 GHz SUBSCRIBER MODULE or a “Low Power” 5.2 GHz Subscriber
Module:
Module:
the passive reflector will change the radiated pattern to 6°
horizontal by 6° vertical.
I F USING A 2.4 GHz SUBSCRIBER MODULE:
the passive reflector will
change the radiated pattern to 17°
horizontal by 17° vertical.
• Set the web page to auto-refresh (see
Configuration
section for further information)
• Go to Alignment web page. Ensure that “
RSSI Only Mode
” is disabled.
• Click “
Enable Aiming Mode
” button.
• The module has a series of states that it will go through to register to an access point.
Those states are: scanning, syncing, registering, and registered. RSSI and Jitter will not
report on the web page till the unit is registered. If the module will not register ensure that
there is line-of-sight, the access point module is transmitting, the color codes match, and
that the subscriber is within the appropriate distance to the access point as specified by
Canopy.
report on the web page till the unit is registered. If the module will not register ensure that
there is line-of-sight, the access point module is transmitting, the color codes match, and
that the subscriber is within the appropriate distance to the access point as specified by
Canopy.
• Slowly adjust the positioning of the subscriber module and monitor the Alignment web
page for a reading of the RSSI and Jitter. Lock down the module when appropriate.
• Click “
Disable Aiming Mode
” button.
• Perform a link test to check the efficiency of the link. See
Link Test
section for further
information. The efficiencies must be above 90% in both the up and down link for major
packet loss to not occur.
packet loss to not occur.